btrfs-send(feed) - phpMan

BTRFS-SEND(8)                    Btrfs Manual                    BTRFS-SEND(8)

NAME
       btrfs-send - generate a stream of changes between two subvolumes
SYNOPSIS
       btrfs send [-ve] [-p <parent>] [-c <clone-src>] [-f <outfile>] <subvol>
       [<subvol>...]
DESCRIPTION
       This command will generate a stream of instructions that describe
       changes between two subvolumes. The stream can be consumed by the btrfs
       receive command to replicate the sent subvolume on a different
       filesystem. The command operates in two modes: full and incremental.
       All subvolumes involved in one send command must be read-only (ie. the
       read-only snapshots and this status cannot be changed if there's a
       running send operation that uses the subvolume).
       In the full mode, the entire subvolume data and metadata will end up in
       the stream.
       In the incremental mode (options -p and -c), there can be one or more
       parent subvolumes that will establish the base for determining the
       changes. The final stream will be smaller compared to the full mode.
       It is allowed to omit the -p <parent> option when -c <clone-src>
       options are given, in which case btrfs send will determine a suitable
       parent among the clone sources itself.
       You must not specify clone sources unless you guarantee that these
       snapshots are exactly in the same state on both sides, the sender and
       the receiver.
       Options
       -e
           if sending multiple subvolumes at once, use the new format and omit
           the end cmd marker in the stream separating the subvolumes
       -p <parent>
           send an incremental stream from parent to subvol
       -c <clone-src>
           use this snapshot as a clone source for an incremental send
           (multiple allowed)
       -f <outfile>
           output is normally written to standard outout so it can be eg.
           piped to receive, use this option to write it to a file
       --no-data
           send in NO_FILE_DATA mode
           The output stream does not contain any file data and thus cannot be
           used to transfer changes. This mode is faster and useful to show
           the differences in metadata.
       -v|--verbose
           enable verbose output, print generated commands in a readable form,
           (each occurrence of this option increases the verbosity level)
       -q|--quiet
           suppress all messagese except errors
EXIT STATUS
       btrfs send returns a zero exit status if it succeeds. Non zero is
       returned in case of failure.
AVAILABILITY
       btrfs is part of btrfs-progs. Please refer to the btrfs wiki
       http://btrfs.wiki.kernel.org for further details.
SEE ALSO
       mkfs.btrfs(8), btrfs-receive(8)

Btrfs v4.9.1                      08/06/2017                     BTRFS-SEND(8)